INVENTOR DR2VI32-09WFI/DR2VO32-09 Benutzerhandbuch Seite 13

Step 4: Select the Wi-Fi
Network and enter the
password. Press Confirm
to proceed. The pairing
process may take some
time.
Note: The pairing
indication on the display
of the air conditioner, may
disappear during this step.
Step 7: Press "Confirm hot
spot connection, next" as
marked in the image above
to start the pairing process.
Step 5: Plug in the air
conditioner to the power
supply and turn it on. Set the
air conditioner to Cooling
Mode, Low Fan Speed and
30°C Temperature. Press
Confirm to proceed.
Step 6: Press "Go to Connect" to enter your mobile
device settings. Connect to the WiFi with name (SSID)
"U-AC-XXXX". Return to Inventor Control once connected.
Troubleshooting:
If the pairing process is not successful:
Verify that the router is broadcasting at 2.4GHz.
l
If the router has dual band broadcasting, verify that the
l
network names (SSIDs) are different. For additional help,
contact your router/internet provider.
Verify that the Wi-Fi password is WPA2-PSK encrypted, and
l
the authorization type is set to AES.
Make sure that the router is within WLAN range of the air
l
conditioner and no repeaters are installed.
Power off the router, the air conditioner, and the device
l
(tablet or mobile) and allow 5 minutes.
Restart the pairing process from Step 2.
l
If the pairing is not successful, repeat the process with a
l
different smart device (tablet or mobile).
Contact Inventor's After Sales Dept.
l
11