Inhaltsverzeichnis
Werbung
Installation
Installation Methods
Fig.2
A drain-downhill installation
should be guaranteed
safety valve
ES8/10/15/30V-Q1(EU) Installation Reference
Diagram
Installation warning:
purchased model. Installation should be done in accordance with the directions
of the inlet and out pipes shown in the illustration; otherwise, incorrect
installation direction may lead to misoperation of the overheating protection
device and cause damage.
Installation should be performed by our after service staff or those
designated by our after-sales department. The water heater uses the
wall-mounted installation method.
Locate the water heater according to the requirements for use. Use water
pipe (PP-R pipe is suggested) to install the pipe line. For easy maintenance
and removal, loose joints shall be installed in the appropriate locations of the
water inlet and outlet pipes.
According to the requirements of installation dimensions, churn drill shall be
used to drill two holes on the wall with depth of 65mm and 12mm in diameter,
and insert the expansion hooks into the holes and fix them firmly and hang
the water heater vertically to the expansion hooks. Check the fastness.
Install accessories such as safety valve, water outlet pipe in accordance with
Fig. 2. Take care to add raw materials tape for sealing to prevent water
leakage.
Confirm the water supply location, and connect the water inlet and outlet
pipes and the tap water pipe to the desired place respectively. Fill the inner
pot with water and check for leakage; reconnect again if there is water
leakage.
Notes: Loosen it only when the frame is reliably hung to the hook to avoid
falling down of the water heater, thus to cause physical injuries or property
damage.
safety valve
A drain-uphill installation
should be guaranteed
ES10/15V-Q2(EU) Installation Reference Diagram
Before installation, please carefully verify your
7
Cold water inlet
Hot water outlet
Werbung
Inhaltsverzeichnis
