Preparation Of The Dishes - Fagor CCO-320ICW Installations-, Gebrauchs- Und Wartungsanleitung

EN
Use the SELECT (Fig. 12) switch to select position I, II or III (Fig. 12). The WASH TEMP (Fig. 12) and RINSE
TEMP (Fig. 12) displays light up and water starts to enter the appliance.
The fill and machine preheating processes take place. This process may last about 30 minutes.
The machine will be operative once the digital thermometers reach
the temperatures in the tank WASH TEMP (Fig. 12) > 60ºC and in
the boiler RINSE TEMP (Fig. 12) > 70ºC.
The appliance has an automatic energy saving function which, while
the appliance is not washing, makes the boiler lower the maintenance
temperature to approximately 70ºC. When the appliance starts to
wash baskets again, the boiler heating nominal value is activated to
the defined value (85ºC by default).
During the first heating of the day, the boiler may reach higher temperatures than
normal due to the heating inertia as the boiler water is cold. This is normal.
After start-up, insert a couple of baskets approximately half an hour before starting
the wash to warm up the machine and to prevent the temperature from falling on
starting the wash.

5.7 Preparation of the dishes

Before starting the wash process, the dishes should be prepared correctly. It is essential to comply with the
following requirements:
✓ Remove large pieces of waste and quickly rinse all the dishes before placing it in the baskets.
✓ Soak the cutlery and even the plates when these are to be washed if they have not been used recently.
✓ NEVER rinse/soak with domestic detergents, bleach or similar products, as these react with those
used in the appliance, creating large quantities of foam. Only use clean water.
✓ First wash glassware (tumblers, glasses, jugs,...).
✓ Place wineglasses, cups and glasses upside down in the basket.
✓ Make sure that the maximum height of the basket including the elements to be washed does not
exceed 390 mm.
✓ Do not overload baskets. Leave space to permit the wash water to clean the items.
✓ Use the right basket for each element to be washed. Consult your supplier.
✓ Place trays in the baskets designed for this purpose, with the shortest side in a vertical position (max.
height basket + tray = 390 mm).
✓ Insert plates on a slant with the internal surface facing upwards in the basket with spikes and insert
them with the front of the plates facing the entrance.
✓ Place cutlery in a basket without spikes with a thicker base and spread out.
78
To start filling the machine, it is essential that the door is totally closed.
The appliance does not operate if it detects that the door is open.
HEATING UP