Using The Hairdryer; Cleaning And Maintenance - BRAYER BR3023 Bedienungsanleitung

6 EN
• Examine the unit for damages, in case of damage
do not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. When using the unit in
the mains with 60 Hz frequency, the unit does not
need any additional settings.
• Wipe the unit with a clean, slightly damp cloth to
remove dust, and then wipe it dry.
• Unwind the power cord to its full length while using
the unit.

USING THE HAIRDRYER

• Make sure that the operation mode switch (1) is set
to the position «0».
• Unwind the power cord completely.
• Insert the power plug into the mains socket.
• Use the switch (1) to set the required operation
mode:
- «0» — the hairdryer is off;
- «1» — warm air supply;
- «2» — hot air supply.
• Note: — during the first operation a foreign smell
and a small amount of smoke can appear from the
heating element, this is normal and it is not covered
by warranty.
• After finishing operation, switch the hairdryer off
by setting the switch (1) to the position «0», and
unplug it.
NOZZLE
• Use the nozzle (3) when you need to focus the
power of drying on a small area (for example, a curl
or a wave) or when you want to straighten wavy hair.
• Attach the nozzle (3) to the unit body. The nozzle (3)
allows directing a narrow air flow of high intensity at
a definite hair lock.
• Insert the power plug into the mains socket. Use the
switch (1) to set the necessary operation mode.
• Periodically straighten the power cord if it gets
twisted during operation.
OVERHEATING PROTECTION
• The overheating protection system switches the
hairdryer off if the outgoing air temperature is above
the limit.
• If the hairdryer is switched off during operation, set
the switch (1) to the position «0», unplug the unit
and make sure that the air inlets and outlets are
unblocked.
• Let the unit cool down for 5-10 minutes and then
switch it on again. Do not block the air inlets during
operation of the hot air styler and
• avoid getting of hair into the air inlet grid (4).

CLEANING AND MAINTENANCE

• The hairdryer is intended for household use only.
• Set the switch (1) to the «0» position, disconnect the
hairdryer from the mains and let it cool down.