GYS GYSFLASH 30.24 HF Bedienungsanleitung Seite 17

BATTERY CHANGE MODE CONFIGURATION
CHANGE BATTERY
12V
CHANGE BATTERY
12V
• Push the START/STOP key to start the mode.
• During use the current consumed and the instanta-
neous voltage are displayed.
• When changing the battery ensure the polarity is
correct. While exchanging the batteries, be careful
not to disconnect the charger clamps to avoid loss of
electronic data.
Warning: polarity reversal can damage the vehicle electronics.
POWER SUPPLY MODE (OPTIONAL)
This mode is intended for expert users only. This mode enables the charger to be used as a stabilised power supply, with regulated
voltage and adjustable maximum current. By default this mode is inactive and doesn't appear in the mode list. It can be activated
via the Advanced menu (see page 19).
Adjustment of the voltage regulation and current limitation :
The voltage regulation can be adjusted from 2V to 30V and the maximum current from 2A to 30A (or from 2A to 15A above 16V):
POWER SUPPLY MODE CONFIGURATION
POWER SUPPLY
U=13.5V I<30A
POWER SUPPLY
U=19.6V I<15A
POWER SUPPLY
U=19.6V I<10A
NOTE: Unlike the other modes, when in Power Supply mode, the charger does not compensate cables voltage drop.
In this mode, the voltage displayed is the charger output voltage (and not the voltage on the clamps).
CONFIGURATION MENU
Access to configuration menu :
To browse in the sub menu press the
«Select» key :
GYSFLASH 30.24 HF
Start up :
• Connect
1 : Red clamp to the (+) of the battery / battery terminal,
in such a way that the battery can be changed without
disconnecting the clamp.
2 : Black clamp to the vehicle chassis or earth.
6V
12V
24V
STARTING BATTERY CHANGE
CHANGE BATTERY
Start up:
• Push the START/STOP key to start the mode.
2.0V
• During use the current consumed and the instanta-
2.1V
...
neous voltage are displayed.
30.0V
2A 2A
3A 3A
... ...
30A 15A
3 sec - Mode
MODE
languages > restart > lock showroom > charge type > cable check >
SELECT
ADVANCED MENU > Reset Memory
U=12V
STARTING POWER SUPPLY
POWER SUPPLY
U=19.6V I<15A
EN
CHANGE BATTERY
U=12.9V I=26A
POWER SUPPLY
U=19.6V I=10A
17