Step 5 Projecting; Projecting The Picture; Turning Off The Power - Sony VPL-VW270 Kurzreferenz

Step 5

Projecting the Picture

1
Turn on both the unit and the
equipment connected to the unit.
2
Press INPUT to display the input
palette on the screen.
3
Select the equipment from which you
want to display images.
Press INPUT repeatedly or press M/m/
(enter) to select the equipment from
which to project.
Example: To view the picture from the
video equipment connected to the HDMI
1 connector of this unit.

Turning Off the Power

1
Press the ?/1 (ON/STANDBY)
button.
A message "POWER OFF?" appears on
the screen.
2
Press the ?/1 (ON/STANDBY) button
again before the message disappears.
The ON/STANDBY indicator flashes in
green and the fan continues to run to
reduce the internal heat.
The fan stops and the ON/STANDBY
indicator changes from flashing green to
remaining red.
The power is turned off completely, and you
can disconnect the AC power cord.
Projecting
Note
Never disconnect the AC power cord while the
indicator is flashing.
Tip
You can turn off the unit by holding the ?/1
(ON/STANDBY) button for about 1 second,
instead of performing the above steps.
For more information, refer to
"Projecting" in the Operating Instructions
contained in the supplied CD-ROM.
17
GB