Cleaning The Body And Control Panel; Cleaning The Water Intake Filters - Beko WTV6712BC1 Bedienungsanleitung

C
INFORMATION
• Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents for
stainless steel.
A
WARNING
• Never use steel wool or wire wool. These
will damage the painted, chromated and
plastic surfaces.
4.4.3 Cleaning the body
and control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.

4.4.4 Cleaning the water intake filters

There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to
enter the washing machine. Filters should be
cleaned as they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses
to access the filters on the water intake
valves. Clean them with an appropriate
brush. If the filters are too dirty, remove
them from their places with a pliers and
clean in this way.
3. Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
4. Replace the seals and filters carefully and
tighten their nuts by hand ensuring there are
no leaks.
22 / EN
4.4.5 Draining remaining water
and cleaning the pump filter
The filter system in your machine prevents
solid items such as buttons, coins and fabric
fibres clogging the pump impeller during
discharge of washing water. Thus, the water
will be discharged without any problem and the
service life of the pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine
(e.g., when moving to another house) and in
case of freezing of the water, water may have
to be drained completely.
A
CAUTION!
• Foreign substances left in the pump filter
may damage your machine or may cause
noise problem.
• If the product is not being used, shut the
tap shut, remove mains pipe and drain the
water inside the machine against any likely
freezing.
• After each use, turn off the water tap to
which the mains hose is connected.
In order to clean the dirty filter and discharge
the water:
1 Unplug the machine to cut off the supply
power.
A
CAUTION!
• Temperature of the water inside the
machine may rise up to 90 ºC. To avoid the
burning risk, clean the filter after the water
inside the machine is cooled down.
2. Open the filter cover.
Washing Machine / User Manual