Cd-Player; Programming Track Numbers - Philips AZ1024/12 Benutzerhandbuch

CD Player
Playing a CD
• This CD player plays Audio Discs including
CD-Recordables (CD-R) and CD-Rewritables
(CD-RW).
• MP3, CD-ROM, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback.
IMPORTANT!
CDs encoded with copyright protection
technologies by some record companies may
be unplayable by this product.
1 Adjust the Source selector to CD.
2 Open the CD door, and insert a CD with
the printed side facing up, then press the CD
door gently to close.
➜ Display shows --, and later the total
number of tracks.
3 Press 2; to start playback.
➜ PLAY/PAUSE LED lights up.
4 To pause playback, press 2;.
➜ PLAY/PAUSE LED flashes.
5 To resume, press 2; again.
6 To stop CD playback, press 9.
Helpful hints:
CD play will also stop when:
– you open the CD door;
–
you select TUNER or
–
the CD has reached the end.
Selecting a different track
∞/ § SKIP
• Press
the desired track number appears in the dis-
play.
• In the pause/stop position, press 2; to start
playback.
All manuals and user guides at all-guides.com
2)
(see
OFF sound source;
once or repeatedly until
Finding a passage within a
track
1 During playback, press and hold ∞ or § .
➜ The CD is played at high speed and with
reduced volume.
2 When you recognize the passage you want,
release ∞ or § to resume normal playback.
Helpful hints:
–
When your searching reaches the end of the
last track, the CD goes to stop mode.
Programming track num-
bers
You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1 In the stop position, press PROG. to
activate programming.
➜
"0" flashes. (see
➜
PROG LED also flashes.
2 Press ∞ or § to select your desired track
number.
3 Press PROG. to store the desired track
number.
➜
"0" flashes for you to program the next
track.
4 Repeat steps 2 to 3 to select and store all
desired tracks in this way.
➜
If you attempt to store more than 20
tracks, no track can be selected and the
display shows flashing - - - - .
5 To play your program, press 2;.
➜
PROG LED flashes during playback.
Helpful hints :
–
When playback of your program comes
to the stop position, your set will return
to normal playback.To re-enter program
mode, press PROG in the stop position.
3)