Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WEIGHING MODE
1.
Place the scale on an even, hard and stable surface.
2. Before turning the scale on place a kitchen bowl on it (if you wish to use it).
3.
By pressing the ZERO/ONOFF button turn on the weighing mode.
4. Wait until all the information is displayed on the LCD display.
5
Place the object to be weighed on the scale (into the bowl) and the LCD display will show the measured
weight of the object.
Unit conversion
This digital kitchen scale weighs in both metric (g, ml) and imperial (lb:oz, fl 'oz)
units. Press the conversion button on the bottom side of the scale to set the
desired unit of measure.
Display of liquid volume (milk, water)
1.
Place a container on the weighing surface.
2. By pressing the ZERO/ON/OFF button reset the weight of the container to zero, so that a "0" is displayed.
3.
Pour the liquid into the container, the display will show the liquid.
4. To display the volume of the liquids, press the MODE button and select on of the options WATER, MILK,
then the desired liquid volume will be shown on the display.
ZEROING AND TARE FUNCTION
These functions are used to gradually measure the weight of various portions added to the previous ones,
which remain on the scale. Place the fi rst portion on the scale and its weight will be shown on the display.
Before adding another portion on to the scale press the ZERO/ON/ OFF button and the value on the display
will be reset to zero ("0"). This step can be repeated.
Each time the ZERO/ON/OFF button is pressed the LCD display will show " ----- " or "0g". " ----- " means that
the state is unstable, so please wait a while. When "0g" is displayed an icon "O" or "T" (depending on the
weight) will light up in the bottom left corner, indicating that the zeroing function is active. The maximum
capacity will not change.
If the total sum of the weights of all the portions on the scale is lower than 200 g then the zeroing function
will automatically be used.
If the total sum of the weights of all the portions on the scale is higher than 200 g then the TARE function will
automatically be used.
Note: You may turn off the scale using the ZERO/ON/OFF button or it will automatically turn itself off after
2 minutes.
Warning messages
1.
The battery is fl at, replace with a new battery.
2. Scale overloaded – the maximum load of 5 kg is displayed on the scale. Please remove
the portion being weighed from the scale to prevent damage.
MAINTENANCE AND CLEANING
1.
To clean the scale use a damp cloth and make sure that no water gets inside the scale. DO NOT USE any
chemical cleaning agents / abrasive cleaning agents.
Do not submerge the scale in water!
2. All plastic parts that come into contact with greasy substances such as spices, vinegar or fl avourings,
must be cleaned immediately. Prevent the scale from being stained by citrus juice!
3.
Always keep the scale in a horizontal position
GB
19
Werbung
Inhaltsverzeichnis
