Error Code - eta 953490010G Bedienungsanleitung

• The package includes a handle and 2 screws. Remove (pull up slightly) the black gasket
from the inside of the door. The gasket is flexible enough and covers two screw holes.
Insert the screws from the inside of the door outwards, attach the handle and tighten the
screws well on the inside.
Setting The Temperature Control
1 2
Temperature setting in selected zone
• To unlock, hold down button 1
upper or lower cooling zone. You set the temperature with buttons 3 and 4 (step 1°) in
the range 12-18 °C (upper zone) or 5-14 ° C (lower zone)
• You set the temperature with buttons 3 and 4 (step 1°) in the range 12-18° C (upper
zone) or 5-14° C (lower zone)
• When all the key no operation for 20 seconds, the key will be locked automatically. After
locking, the plus 3 and minus 4 keys cannot be operated. The unlock key 1 and light / CF
key 2 operate normally
Recommended temperature
Red Wine
Dry / White Wine
Rose / Sparkling Wine
Auto light off function
When all the key no operation for 10 minutes, the lamp will turn off automatically.

Error code

„EE" is displayed when the temperature probe is short-circuited or
EE
disconnected, flashes, and cooling is stopped
LL: When the temperature measured by the temperature probe is lower than
LL
0 degrees Celsius, "LL" is displayed, flashing, and the cooling is stopped
HH: When the temperature measured by the temperature probe is higher than
HH
37 degrees Celsius, "HH" is displayed, flashing, and cooling is stopped
1 - UNLOCK KEY:
• short press to switch the upper
• long press for 2 seconds to unlock
2 - LIGHT/ °C;°F
• short press to turn on or off
• long press to switch between
3 4
3 - ADD key: temperature setting
4 - MINUS key: temperature setting
. for 2 seconds. Now press shortly
14 °C - 18 °C
9 °C - 14 °C
5 °C - 8 °C
EN - 35
room/lower room setting state
Fahrenheit and Celsius
to select the
EN