Replacing The Power Cable - EINHELL TC-BS 8038 Originalbetriebsanleitung

tension the sanding/grinding belt.
5.3 Adjusting the position of the belt
(Fig. 6/Item 2)
•
Hold the belt sander/grinder with the sanding/
grinding plate at the top.
•
Switch on the belt sander/grinder.
•
By turning the setting screw (2) the belt positi-
on should be set so that the sanding/grinding
belt is at the center of the two drive rollers.
6. Operation
6.1 Switching ON/OFF (Fig. 7)
To switch on:
Press the ON/OFF switch (5).
Continuous operation:
Secure the switch (5) with the locking button (4).
To switch off :
Press the ON/OFF switch (5) briefl y.
The machine can be operated on a temporary or
permanent setting.
6.2 Instructions for use
Important. Never hold the workpiece you wish to
sand/grind in your hands. Secure the workpiece
on a sturdy surface or using a vise.
•
Allow the belt sander/grinder to start before
you place it on the workpiece.
•
Do not switch off the belt sander/grinder as
long as the sanding/grinding belt is in contact
with the workpiece.
•
Always hold the belt sander/grinder with both
hands whilst it is in use.
•
Always sand wood in the direction of the
grain.

7. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_TC_BS_8038_SPK1.indb 16 Anl_TC_BS_8038_SPK1.indb 16
GB
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 16 -
9.
The
ven
mat
recy
mad
and
you
be t
disp
suc
loca
10
Sto
chil
free
ratu
too
18.09.13 13:49 18.09.13 13:49