End Of Program; Odour Feature - Beko TR310 Bedienungsanleitung

The inside of the drying machine
shall be extremely hot when you
cancel the program during machine
operation, so run the refreshing
program to allow it to cool down.

6.11 End of program

When the program ends, the LED's of End/
Wrinkle Prevention and Fibre Filter Cleaning
Warning on the program follow-up indicator
turn on. Loading door can be opened and
drying machine is ready for another operation.
Turn the On/Off/Program Selection button to
On/Off position in order to turn off the drying
machine.
If the Wrinkle Prevention mode
is active and the laundry is not
removed after the program is
completed, the wrinkle prevention
function activates for 2 hours to
prevent the laundry inside the
machine to get wrinkled. The
program tumbles the laundry with
10-minute intervals to prevent them
from wrinkling.

6.12 Odour feature

If your drying machine has odour feature, read
the ProScent manual to use this feature.
6.13 SteamCure Odour and
Wrinkle Removal Function
SteamCure is a refresher function that helps
ironing the dry clothes that worn very little and
aims to reduce airborne (cigarettes, food, etc.)
odours.
It is recommended to wash the clothes to
remove odours that can be absorbed by them
such as perfumes, deodorants and sweat.
Do not dry products that includes sharp or hard
accessories and leather.
Filling the water tank
1 blue wing in the machine performs the
process of watering the laundry.
If the wing is on top, you can manually rotate
the drum to the lower position and fill the water.
Before using the Steamcure program, the
water in the filling container at max. Level must
be filled manually into the wing.
To remove wrinkles, tap or drinking water
should be used.
A few drops of water that may overflow from
the wing during filling will not cause any
problem.
56
Additives or descaling agents
should not be used.
Chemicals that can be dissolved
with liquid chemicals and liquids
should not be used.
Starting the Program
The wing should be brought to the lower
position and should be filled with water up
to the marked area with the filling container.
The SteamCure program must be selected.
When you select the program, the screen
time will appear as 10 minutes. The time
program is set to the desired time by
pressing the selection button and the Start/
Standy-By button is pressed.
For an effective odour removal,
it is recommended to operate 1-6 pieces of
dry clothing for 50 minutes.
This function does not clean clothes, it
reduces the odours and wrinkles and allows
you to wear them again.
Dryer / User Manual