Avintage AVI76PREMIUM Gebrauchsanweisung Seite 46

Compartment selecting switch (lower or upper one). Once the compartment has been
H selected, it will show setting temperature as flash, 5 seconds later flash will stop and setting
temperature will be showing
Alarm cancel switch, press once to cancel the alarm. Press and hold 5 seconds to change
I
Celsius or Fahrenheit.
J Light ON/OFF switch, turn on and turn off the light.
Temperature selection
The wine cooler has two temperature zones. The temperature setting of upper zone is adjustable with the
range 5-12°C, which is ideal for storing sparkling and white wines. The temperature setting of lower zone
is adjustable with the range 12-20°C, which is ideal for storing white and red wines.
NOTE: both two zones temperature could be set at 12ºC, and it is workable at the same time. But
for optimal performance, once one zone is set at 12ºC, we suggest another setting for the other
zone with 3°C difference at minimum (example: 5°C upper and 8°C lower). Maximum temperature
difference between both compartments is 10°C. Always set cooler temperature in the upper
compartment and warmer temperature in the lower compartment (example: 5°C upper and 15°C
lower).
• To select the temperature zone, press (H) once, upper zone will flash, (H) key pressing again to switch
it to lower zone. Setting temperature could only be set under display flash status.
• You can touch key "+" (C) and key "-" (B) to set the internal temperature for the selected zone. The
degrees indicators will appear in the display window marked
• When the unit is plugged in for the first time, the LED readouts will show the original temperature set
previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set the desired temperature.
• The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or the temperature will
decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take around 10
minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same circumstance, it will
take around 20 minutes to decrease the wine cooler's temperature from 12℃ to 5℃. The less the
temperature span is, the less time it will take. The setting temperature of upper zone should be lower than
the setting temperature of lower zone
Temperature display
Display show at its setting.
To view the actual temperature in either zone at any time, touch key (B) and key (C) for 3 second, the
display will display two zone's actual temperature with flashing, and it will quit by holding stop.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature setting on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to wait
5 minutes before turning it on again.
Temperature alarm
The alarm will sound and the temperature display will flash when:
for upper zone and for lower zone.
46