Overload Protection; Transportation And Storage; Know Your Product - Ryobi RY120PWA Bedienungsanleitung

■
Use a garden hose with a maximum length
of 15 m and minimum diameter of 18 mm
(3/4 in).
■
Before each use, ensure that the accessory
is securely attached to the trigger gun.

OVERLOAD PROTECTION

The product has an overload protection device
that is activated when overheating or when a
current spike occurs, automatically shutting
down the power within the product. To resume
operation, disconnect the product from the
power supply, wait for about 15 minutes, and
reconnect the product to the power supply.

TRANSPORTATION AND STORAGE

CAUTION! Mind the weight of the product
when selecting the storage location and during
transportation to prevent accidents or injuries.
■
Stop the product, disconnect from the power
supply, and allow the product to cool down.
Disconnect the product from the water
supply before storing or transporting. Never
place the product in any position other than
upright.
■
Clean all foreign materials from the product.
Store it in a cool, dry, and well-ventilated
place that is inaccessible to children. Keep
the product away from corrosive agents
such as garden chemicals and de-icing
salts. Do not store the product outdoors.
■
Remove water from all hoses and the pump,
and empty the detergent tank before storing
the product.
■
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
■
Store the product indoors only. Storing the
product in an area with temperature below
0°C will damage the product.
MAINTENANCE
■
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
■
Servicing requires
knowledge and should be performed only by a
qualified service technician. Have the product
serviced by an authorised service centre only.
manufacturer's
accessories, and
extreme care and
■
Turn off the product, and disconnect the
plug from the power outlet. Disconnect the
product from the water supply. Allow the
product to cool down:
●
before servicing
●
before clearing a blockage
●
before checking, cleaning, or working on
the product
■
You may make adjustments or repairs
described in this manual. For other repairs,
contact an authorised service centre.
■
Regularly inspect and maintain the high
pressure cleaner for safe operation. RYOBI
recommends inspecting the product every
6 months.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that
the product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.

KNOW YOUR PRODUCT

See page 145.
1. Carry handle
2. Hose hanger
3. Water inlet filter
4. Handle screws
5. Operator's manual
6. Lance hook
7. Nozzle cleaning tool
8. Power cord holder
9. On/off switch
10. Power cord
11. Water inlet port
12. Detergent tank cap
13. Detergent tank
14. Wheel
15. Hose release button
16. Water outlet port
17. Trigger handle holder
18. Spray angle
19. Spray angle lock button
20. Trigger handle lock
21. Trigger
22. Hose lock button
23. High pressure hose
24. Turbo lance
25. Vario lance
26. Garden hose
27. RYOBI detergent
28. Garden hose connector
NOTE: If using a detergent, refer to the Material
Safety Data Sheet of the detergent.
5
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR