Maintenance - Husqvarna X-COM Active HP500C-01 Bedienungsanweisung

To accept, end or dismiss a phone call
If your mobile device is connected to the product with
®
Bluetooth wireless technology, a signal is heard in the
earmuffs when there is an incoming phone call.
• Push the mode button to accept or end the phone
call.
• Push the mode button for 1 second to dismiss an
incoming phone call.
Note:
A beep sound tells you when the phone call
is accepted or dismissed.
Audio message
CALL ENDED
To transfer the phone call to the team
1. Push the mode button to accept the phone call.
2. Push the mode button quickly 2 times to transfer the
phone call to the team.
Note:
An audio message tells you when the phone
call has transferred. Refer to the table below.
Audio message
CALL TRANSFERRED
TO TEAM
To disconnect the phone call in the team
• Push the mode button 2 times quickly.
Note:
An audio message tells you when the phone
call has disconnected. Refer to the table below.
Audio message
CALL DISCONNECTED
FROM TEAM
To do maintenance on the product
CAUTION:
product fully into water.
CAUTION:
cleaning agents that contain solvents and/or
alcohol can decrease the protective function.
12
Information
The phone call has
ended.
Information
The phone call has trans-
ferred to the team.
Information
The phone call has dis-
connected from the team.

Maintenance

Do not flush or put the
Spray, liquids or other
To adjust the volume
• Push the volume up button or volume down button to
adjust the volume. A beep sound tells you when the
volume is at the minimum or maximum level.
To set to ambient sound mode
Ambient sound mode lets you hear the sounds around
you.
• Push the ambient sound button.
Note:
An audio message tells you the status of the
ambient sound mode.
Audio message
AMBIENT LEVEL HIGH
AMBIENT LEVEL MEDIUM
AMBIENT LEVEL LOW
AMBIENT LEVEL OFF
To stop the product
• Push and hold the on/off button for 1 second.
Note:
An audio message tells you the battery
status and the LED indicators go out. A beep sound
tells you that the product is off.
To stop the product by force
• Push and hold the on/off button for 12 seconds.
CAUTION:
spare parts.
1. Clean the product regularly. Use a cloth and a weak
soap solution.
2. Do a check of the condition of the sealing rings and
the foam rubber inserts before each use.
Use Husqvarna original
1957 - 001 - 06.07.2023