Fitting The Inverter; Mounting Instructions; Mounting The Inverter - Dometic SINEPOWER DSP 212 Montage- Und Bedienungsanleitung

DSP 212, DSP 224, DSP 412, DSP 424
No. in
fig. 2,
Description
page 3
3 USB connection
4 AC outlet
5 DC plug
6 Fan (backside)
7 DSP412, DSP424 only: Connection for external switch
6

Fitting the inverter

6.1

Mounting instructions

When selecting the installation location, observe the following instructions:
• The inverter can be mounted horizontally or vertically.
• The inverter must be installed in a place that is protected from moisture.
• The inverter may not be installed in the presence of flammable materials.
• The inverter may not be installed in a dusty environment.
• The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces. The minimum clearance
around the inverter must be at least 5 cm (fig. 3, page 4).
• The air intake on the underside or the air outlet on the back of the inverter must
remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the inverter's maximal output load is reduced.
Thereby the inverter may shut down due to overload.
• The device must be installed on a level and sufficiently sturdy surface.
A
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
6.2

Mounting the inverter

➤ Mount the inverter as shown (fig. 4, page 4).
EN
Fitting the inverter
15