Assembly And Adjustment - CONSTRUCTOR CHAGD2003-BM Übersetzung Der Originalanleitung

DESCRIPTION
1. Nozzle
2. Ventilation slots
3. On/Off switch

ASSEMBLY AND ADJUSTMENT

Prior to assembly and adjustment
always unplug the tool.
Use only one hand to hold the tool. Do not place
your other hand over the air vents. Prior to operation
mount the correct accessory for the application.
If you are not sure about the
correct setting, start with a low
temperature setting and gradually
increase the temperature until
you achieve optimum results.
Mounting the correct accessory
This tool is supplied with a set of accessories for
different applications.
Make sure that the tool is switched
off and the nozzle has cooled
Falling down nozzle can set an
object on fire. Nozzles must be
mounted firmly and secure on the
Touching a hot nozzle can lead to
serious burns .Before attaching or
replacing a nozzle, allow the unit to
cool down completely or use a
A hot nozzle can set a surface on
fire. Place down hot nozzles only
on fireproof surfaces.
An incorrect or defective nozzle
can lead to heat accumulation and
damage the unit. Use only original
nozzles according to the table that
are suitable for your unit.
Set the desired accessory onto the nozzle.
down.
unit.
suitable tool.
INSTRUCTIONS FOR USE
Always observe the safety
instructions and applicable
_ Use only one hand to hold the tool. Do not place
your other hand over the air vents.
_ Aim the mouthpiece of the machine at
the workpiece.
_ Heat the material a few seconds before
working it.
_ For optimum result it is recommended to
test the machine first on a small part of
the workpiece.
Prior to operation:
_ Mount the correct accessory for the application.
_ Set the desired air temperature.
Switching on and off
_ To switch the tool on, set the on/off switch to
position: 1 or 2.
Some smoke may be emitted after switching on;
this does not indicate a problem.
_ To switch the tool off, set the on/off switch to
position: 0.
Then set the on/off switch to position 0. Let the tool
cool down before moving or storing it.
Stripping paint
_ Mount an appropriate accessory.
_ Set a high air temperature.
_ Switch the tool on.
_ Direct the hot air onto the paint to be removed.
_ When the paint softens, scrape the paint away
using a hand scraper.
Do not strip metal window
frames, as the heat may be
conducted onto the glass and
When stripping other window
frames, use the glass protection
Do not keep the tool directed at
one spot too long to prevent
igniting the surface.
Avoid collecting paint on the
scraper accessory, as it may
ignite. If necessary, carefully
remove paint debris from the
scraper accessory using
Cooling down
The nozzle and accessory become very hot during
use. Let them cool down before attempting
to move or store the tool.
_ Switch the tool off and let it cool down for at least
30 minutes.
regulations.
crack it.
nozzle.
a knife.
15