SOMFY LW25 Gebrauchsanleitung Seite 3

Installation
[1]. Preparation
a. Cut the box pin to the length
required.
b. Position the box and pin adap-
ters on the motor.
[2]. Installing motor in box
a. Insert the motor in the box.
Take care not to cut the power
supply wires on the edges of the
box when introducing the motor.
b. Let the pins abut against the
motor pin adapters.
[3]. Motor and pin locking
a. Using the relevant tool, pinch
box edges to block motor transla-
tion.
b. To lock the pin, place stop
rings against the CTS , and
screw them.
[4]. Rotation according to power
supply
The LW 25E includes an
additional wire for connecting a
controller
[5]. Accessories for the motor
a. Various pin adapters.
b. Various stop rings for pin.
c. Box adapters.
REPAIR :
Copyright © 2009 Somfy SAS. All rights reserved.
]1[ .a
]2[
.a
.b
]3[
]4[
]5[
Hexa : 6mm Hexa : 5mm Square : 5mm
.a
.c
.d
MS 25
The blind does not move:
Check:
a. Power supply to the motor.
b. Motor wiring.
c. Pins abutting against the motor pin adapters.
d. Motor is not at end of travel.
.b
AMS 25
The motor runs in the opposite direction:
Check:
a. Wiring.
b. Reverse the wires if necessary.
OK
Hexa : 6mm Hexa : 5mm
.b Square : 5mm
Geiger
2