Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION (SITE, TYPE OF SUPPORT, NECESSARY SPACE)
•
Install the HP outdoors at more than 2 meters from the pool.
•
Place the HP on the provided vibration absorbers on a surface that is stable, solid (able to bear the weight of the device) and level (prepare a concrete base if
necessary).
•
Maintain 1 m (30 cm minimum) of open space in front of the vertical air intake grids (behind and on the side of the HP) and 3 m at the outlet of the fan (in front) of
open space without any obstacles.
•
Prepare sufficient space around the HP for maintenance operations.
•
Prepare a water evacuation system close to the HP to protect the installation zone.
•
Keep the HP out of the reach of children, insofar as possible.
The HP should never be installed:
•
In an area covered by sprinkling systems, or subject to spray or running water or mud (close to a road, take into account the effects of wind),
•
Under a tree,
•
Close to a source of heat or of flammable gas,
•
In an area where it would be exposed to oil, flammable gases, corrosive products, and compounds containing sulphur,
•
Close to equipment operating at high frequencies,
•
In a place where snow is likely to accumulate,
•
In a place where it could be flooded by the condensates produced by the device as it operates,
•
On a surface that could transfer the vibrations to the house.
Advice: dampen the possible noise nuisance caused by your HP.
•
Do not install it close to or underneath a window.
•
Do not direct the outlet of the fan towards your neighbors' property.
•
Do not direct the fan outlet (cold air) towards the swimming pool.
•
Install it in an open area (sound waves bounce off surfaces).
•
Install a sound barrier around the HP, making sure to maintain the required distances.
•
Install 50 cm of PVC piping at the water inlet and outlet of the HP.
The HP must be installed and maintained on a fixed and solid basis, with the skids placed under the feet.
•
For concrete, use adapted ø 8 mm lag screws fitted with washers to prevent any loosening.
•
For wood, use adapted ø 8 mm hexagon head screws fitted with locking washers to prevent any loosening
3m mini
- 20 -
The Ottimo HP has four feet and a condensate ex-
traction nozzle included with the product.
the condensate extraction nozzle and the four feet
must be attached before installing the machine,
using the described methode in the figure above.
Werbung
Inhaltsverzeichnis
