Overview Non Verifiable Models - KERN&SOHN SFB Betriebsanleitung

8.1 Overview non verifiable models

Menu block Menu item
Main menu Submenu
PO CHK SET H
Weighing with
SET LO
tolerance range,
see chap. 7.7
PCS H
PCS L
BEEP
P1 REF
A2n0
Zero point
settings
0AUto
0rAGE
0tArE
SPEEd
Zero
P2 COM MODE
Interface
parameter
BAUD
SFB-BA-e-1625
Available settings / explanation
Upper limit value „Tolerance check weighing", input see
chap. 7.7.1
Lower limit value „Tolerance check weighing", input see
chap. 7.7.1
Upper limit value „Tolerance check counting", input see
chap. 7.7.2
Lower limit value „Tolerance check counting", input see
chap. 7.7.2
Acoustic signal for weighing with tolerance range
no
switched off
ok Audio sound when load is within tolerance limits
nG Audio sound when load is beyond tolerance limits
Automatic zero point correction (Autozero) by changing
the display, digits selectable (0.5d, 1d, 2d, 4d)
Zero setting range
Load range where the display after switching-on the
balance is set to zero. Selectable 0, 2, 5, 10, 20, 50, 100
%
Zero setting range
Load range where the display is set to zero by pressing
. Selectable 0, 2, 4, 10 , 20* , 50, 100%.
Automatic taring „on / off", taring range adjustable in menu
item „0Auto".
Not documented
Zero point setting
Continuous data output
CONT
One output for stable weighing value
ST1
Continuous data output of stable weighing
STC
values
PR1
Output after pressing
Manual totalizing, see chap. 7.8.
PR2
Press and the weighing value will be
added to the summation memory and issued.
For automatic add-up see chap. 7.9.
AUTO*
This function is used to issue and add individual
weighing values automatically to the summation
memory on unloading of weighing scale.
For remote control commands, see chap. 10.4
ASK
wirel
Not documented
kit 1
Available Baudrate: 600, 1200, 2400, 4800, 9600*
43