Introduction; Dear Customer; What Is What On The Chain Saw - Husqvarna CS 2240 II Bedienungsanweisung

Dear Customer,

Congratulations on your choice to buy a Jonsered
product!
We are convinced that you will appreciate with great
satisfaction the quality and performance of our product for
a very long time to come. The purchase of one of our
products gives you access to professional help with
repairs and service whenever this may be necessary. If
the retailer who sells your machine is not one of our
authorised dealers, ask for the address of your nearest
service workshop.
It is our wish that you will be satisfied with your product
and that it will be your companion for a long time. Think of
this operator's manual as a valuable document. By
following its content (usage, service, maintenance, etc),
the life span and the second-hand value of the machine
can be extended. If you sell this machine, make sure that
the operator's manual is passed on to the buyer.
Good luck on using your Jonsered machine!
Jonsered has a policy of continuous product development
and therefore reserves the right to modify the design and
appearance of products without prior notice.
1155356-38 Rev.2 2014-12-02

INTRODUCTION

What is what on the chain saw?

1 Cylinder cover
2 Air purge
3 Start reminder
4 Combined start and stop switch
5 Rear handle
6 Information and warning decal
7 Fuel tank
8 Adjuster screws carburettor
9 Starter handle
10 Starter
11 Chain oil tank
12 Product and serial number plate
13 Front handle
14 Front hand guard
15 Muffler
16 Saw chain
17 Bar tip sprocket
18 Guide bar
19 Spike bumper
20 Chain catcher
21 Chain tensioning screw (CS 2240 II)
22 Clutch cover (CS 2240 II)
23 Right hand guard
24 Throttle trigger
25 Throttle lockout
26 Clutch cover (CS 2240S II)
27 Chain tensioner wheel
28 Knob
29 Guide bar cover
30 Combination spanner
31 Operator's manual
–
English 9