Inhaltsverzeichnis
Werbung
General Instructions
Installation: (Faucet)
1. Turn off water supply and drain
lines. Drill (2) two 1" diameter
holes, 4" center-to-center in sink
top where you will be installing
no.1.
2. After unpacking, remove no.5,
no.4 and no.3 from each no.2.
1
sink
2
3
4
5
3.
Place no.1 into holes in sink top
and replace no.3, no.4 and no.5 onto
no.2. Tighten no.5 with a wrench.
4.
Connect water supply lines and
check for leaks.
Installation: (Pop-Up Valve)
1. Remove pop-up drain stopper, with
'o'-ring and flange from pop-up
assembly.
2. Remove rod clip, lift rod, rod guide
nut, rubber washer and rod ball
assembly from drain body.
'o'-ring
pop-up drain
stopper
stem
flange
screw
rubber washer
washer
locknut
ball rod
gasket
nut
drain body
3. Insert drain body from bottom
of sink drain hole, reassemble
flange to drain body, tightening
as far possible.
flange
drain pipe
drain body
sink base
flange flush with
sink bottom
washer
locknut
4. Slide rubber washer on drain
pipe up against bottom of sink.
Tighten washer and locknut
firmly against base for a tight seal.
lift rod
rod clip
rubber
washer
Werbung
Inhaltsverzeichnis
