Ordering Replacement Parts; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL 45.133.80 Bedienungsanleitung

Anleitung_RT_SD_4_8_SPK1:_
GB
6.7 Adjusting the bit chuck (Fig. 9/Item 1)
The bit chuck (1) can be moved into different
positions
Proceed as follows to adjust the bit chuck:
1. Undo the locking screw on the left and right (3).
2. Move the bit chuck (1) to the desired position
3. Re-tighten both locking screws (3).
Important. Before you use the screwdriver, make
sure that the bit chuck is sufficiently secured in the
desired position.
6.8 Changing the tool (Fig. 10)
Important! Set the changeover switch to its centre
position whenever you carry out any work (for
example changing the tool, maintenance work, etc.)
on the cordless screwdriver.
Insert the bit (13) into the bit chuck (1).
To remove the bit (13), pull it back out of the bit
chuck (1).
6.9 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
12
13.09.2008 11:57 Uhr Seite 12

7.3 Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.