Franke FTC 522 Bedienungsanleitung Und Installation Seite 7

INSTALLATION
• The Hood can be installed directly on the
underside of wall-mounted units (650 mm
min. from the Cooker Top) using the snap-
on side supports.
• According to requirements, fit two of the
support brackets for the hood (see table fig.
1) at a distance of 125 mm from the front of
the wall-mounted unit.
• According to the chosen air outlet diameter,
insert the appropriate flange into the upper
exhaust outlet. (fig.2)
• Measure the depth of the wall-mounted unit.
(fig.3)
• Measure the depth of the hood plus the fas-
tening profile depth 20. (fig. 3)
• Adjust the depth of profile 20 accordingly,
cutting it to size.
• Screw the fastening profile 20 to the rear
part of the hood using screws 12f
(2.9 x 9.5) provided. (fig.4)
• Open the ducting carriage.
• Remove the metal grease filters one at a
time, releasing the fasteners provided.
• Close the ducting carriage.
• Insert the Hood until it connects with the
snap-on side Supports. (fig.5)
• Open the ducting carriage.
• Lock it in position by tightening screws Vf
from underneath the Hood. (fig.5)
• Should it be necessary to make adjustments
to the inside of the filter holder element,
proceed as follows:
• Loosen the four adjustment screws Vr
and close the carriage again. (fig.6)
• Move the whole filter holder element un-
til it is properly aligned with the wall-
mounted unit. (fig.7)
• Holding the hood canopy still, extract the
carriage and tighten the adjustment
screws Vr. (fig.6)
• It is now possible to fasten the hood to the
wall-mounted unit using the screws 12a
(3.5 x 16) provided. (fig.8)
• Replace the metal grease filters.
• Close the ducting carriage.
EN
Drilling the Support surface and Fitting the Hood
1
X
10b
10a
9
2
10
5
7
Nische / Niche / Haltewinkel /
Nicchia/ Niche Cornières /
Staffe / Bra-
ckets
SMS 550 mm 25 mm
518-512 mm 9 mm
3
4
Vr
6
12a
8
7
X
7