All manuals and user guides at all-guides.com
guarantee and service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country. You find its phone number in the worldwide
guarantee leaflet. If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
Troubleshooting
1
The suction power is insufficient
-
Perhaps the dust container is full.
If necessary, empty the dust container.
-
Perhaps the filters need to be cleaned or replaced.
If necessary, clean or replace the filters.
-
Perhaps the suction power slide on the handgrip is open.
Close the slide.
-
Perhaps the electronic suction power control is set to a low setting.
Set the control to a higher setting.
-
Perhaps the nozzle, tube or hose is blocked up.
To remove the obstruction, disconnect the blocked-up item and connect it
(as far as possible) the other way round. Switch on the vacuum cleaner to
force the air through the blocked-up item in opposite direction.
2
The dust container full indicator is on.
-
The dust container is full and you have to empty and clean it. Empty
the dust container and clean the filter cone, HEPA dust container filter
and foam filter.
3
Specific types only: hairs are entangled around the brush inside the
mini turbo brush.
-
Clean the mini turbo brush. See chapter 'Cleaning', section 'Cleaning the
mini turbo brush'.
English
17