Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.3 General risks when using the product
The product, hereinafter referred to as "the measuring system", is manufactured according to state-
of-the-art technology and accepted safety rules. Nevertheless, non-intended use can pose a
danger to life and limb of the user or third parties, or lead to impairment of the measuring
system or other property!
Only use the measuring system in a technically faultless state, and only for its intended use, taking
safety and hazard aspects into consideration, and observing the Other applicable documents! Faults
which could threaten safety should be eliminated without delay!
2.4 Intended use
The measuring system is used to measure angular motion and to condition the measurement data
for the subsequent control of industrial control processes.
Intended use also includes:
observing all instructions in the other applicable documents,
-
observing the nameplate and any prohibition or instruction symbols on the measuring system,
-
observing the enclosed documents,
-
operating the measuring system within the limit values specified in the technical data, see
-
Product Data Sheet
2.5 Non-intended use
Danger of death, physical injury and damage to property in case of non-
intended use of the measuring system!
Printed in the Federal Republic of Germany
04/01/2020
As the measuring system does not constitute a safety component according
-
to the EC machinery directive, a plausibility check of the measuring system
values must be performed through the subsequent control system.
It is mandatory for the operator to integrate the measuring system into his
-
own safety concept.
The following area of use is especially forbidden:
-
In environments where there is an explosive atmosphere
-
for medical purposes
-
TR-ECE-BA-DGB-0161-00
TR-Electronic GmbH 2020, All Rights Reserved
Page 23 of 28
Werbung
Inhaltsverzeichnis
