Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- 1 or 2 heating zones
- 1 or 2 adjustable thermostats from 50 to 300°C
- 1 or 2 indicators to signal heating
- 1 or 2 on/ off switches with power lights
- Power: 1 x 1 600 watts, 2 x 1 800 watts or 1 x 3 600 watts
- 4 ajustable feets on GECIC3, 2 ajustable rear feets on GECIK2 and GECII2
This appliance complies with the EC standards.
Installations
Work surface
Choose an easy-to-clean work surface on which to install the appliance. The appliance
must be at least 20 cm from any vertical surfaces that are not heat-resistant for the
planchas GECIC3 and GECII2 - at least 1 cm from any vertical surfaces that are not
heat-resistant for the plancha GECIK2 - in order to prevent damage by heat radiating
from the plates. To ensure maximum ease of use, the top of the irons should be between
85 and 95 cm from the ground.
▪ Place the machine on a flat, firm surface. Do not place on anything that it sensitive
to heat.
▪ Select the temperature according to the type of food to be cooked (see section on
cooking).
▪ Preheat the plancha at the chosen temperature for 10 minutes.
▪ Place the food on the plate and cook to taste.
Place the appliance 20 cm away from any wall or any element sensitive to heat.
Use the button to adjust the temperature.
Unwind and connect the cable securely: firstly to the socket of the appliance and then
to the mains socket. The indicator light will then go on.
The light goes off when the appliance is ready to use.
Protective films prevent the stainless steel from scratches. It's imperative to remove
them before the first use
Before the first use, clean the plancha with a damp sponge.
Electrical connection
The appliances must be connected to the single phase 230 V network using a 16-amp
two-pin plug with earth pin. They are delivered with a power cable, type HO7RNF 3
conductors (phase + neutral + earth), cross-section 1,5 mm².
- 12 -
Werbung
Inhaltsverzeichnis
