Airdesign Susi 2 Betriebshandbuch Und Serviceheft Seite 46

6. Fold the wing up from the trailing edge into 2 or 3 folds, removing excess air and making
sure that the packed leading edge is kept flat and outermost. DO NOT fold the leading edge
back inside the wing. This may damage / distort the polyamide rods.
7. For Packing bag - Undo the clip holding the leading edge in place and secure around the
folded glider. Close the bag with the side clip and top drawstring.
Storage

Avoid packing your glider when it is wet. If there is no other way, then dry it as soon
as possible away from direct sunlight and heat. Be careful to avoid storing your
canopy when damp or wet: this is the most common reason for canopy degradation.

Do not let your glider come into contact with seawater. If it does, rinse the lines,
canopy and risers with fresh water and dry it away from direct sunlight before
storing.

After flight or when storing, always use the inner protection sack (or AIRPack).

When storing or during transport make sure your glider is not exposed to
temperatures higher than 50°C.

Never let the glider come into contact with chemicals. Clean the glider with clean
lukewarm water only. Never clean using abrasives.

For long-term storage do not pack the glider too tightly. Leave the rucksack zip open
when possible to allow any moisture to evaporate.
Transport:
Some materials used in the construction of the glider are sensitive to temperature. Therefore,
the pilot should ensure that the glider is not exposed to excessive heat. For instance, do not
leave the glider in a car during hot summer days.
When packing to send by post use appropriate packing material.
Cleaning:
45