Installation - ZENEC ZEM-W801RM Bedienungsanleitung

INSTALLATION

Step 1:
■ Select the screw by ST4.2x16 length that applies to your vehicle, contained in the
package contents. Screw the metal mounting plate to the car roof. Please remember
not to cover the opening of original dome light.
Metal Plate
Screw ST4.2x16 *4
Step 2:
■ Connect the 6 pin power source cable, signal cable with the video adapter.
Step 3:
■ Connect the 6 pin power source cable to a 12V source, ACC and GND power source in
your car.
Step 4:
■ Pull out the original dome light power wire and signal cable through the opening of
original dome light.
Step 5:
■ Connect the signal cable to the female connector on the unit side.
■ Connect the power wire of dome light on the back unit with original dome light power
wire.
Step 6:
■ Turn on the unit. After the panel is open, fix the unit to the mounting plate with four
screws. Rip off the scraps which may be conglutinated on adhesive foam. Then, use
adhesive foam to cover the four screws.
All manuals and user guides at all-guides.com
26
Car Roof