Faults Table - ETNA VV143 Serie Bedienungsanleitung

FAULTS

Faults table

When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom
The appliance emits a slight
odour when used for the first
time.
The appliance does nothing.
Temperature inside the
appliance too high or too low.
Appliance makes a noise.
Ice building up.
EN 24
Possible cause
New appliance.
Plug not in socket.
Thermostat off.
Thermostat setting incorrect.
The door seals are dirty or the
seals are damaged.
Incorrect positioning of food
in the appliance.
There is an object against the
appliance.
The door has been opened for
too long.
The door is not closed
properly.
Frozen compartment is not
periodically defrosted.
The door does not seal
properly (the seal is dirty, the
door is misaligned or the seal
is damaged, etc.).
Solution
This is normal and disappears
when the appliance starts
cooling.
Insert the plug in the socket.
Adjust the thermostat to the
correct setting.
Adjust the thermostat
properly.
Clean the door seals. Call
the service centre if the door
seals are damaged.
Place foods in the proper
manner in the appliance.
Remove the object.
Make sure that the door is
closed properly.
Defrost the frozen
compartment to remove the
ice.
Make sure that the door is
closed properly. Clean the
door seals. Call the service
centre if the door seals are
damaged.