Samsung SCC-B5394 Bedienungsanleitung Seite 10

Set the LL switch to ON while the AC power
is connected. If any picture roll happens,
you have to adjust the phase using the
phase-control buttons. Press the INC or
DEC button to increase or decrease the
phase by one degree.
2. Switch 2 (LSS): This sens-up mode
accumulates the image fields in memory to
reduce noise but increase the brightness
and contrast rate. When this switch is set to
ON, the camera automatically switches to a
maximum of 128 times of image acquisition
speed to implement a clear picture for
darker image.
3. Switch 3 (H-REV): When this switch is
set to ON, the camera image is reversed
horizontally. If you want to monitor your site
using a mirror, you can use this feature to
see the right image.
4. Switch 4 (V-REV): When this switch is
set to ON, the camera image is reversed
vertically. If your camera reluctantly displays
the vertically reversed image, you can use
this feature to see the right image.
5. Switch 5 (BLC): When this switch is set
to ON, you can view a clear image even
though the camera faces any excessive light
such as sunlight and fluorescent light. When
it is set to OFF, the subject with excessive
light is not clearly shown.
10
8D.indb 10
All manuals and user guides at all-guides.com
6. Switch 6 (FL): When this switch is set to
7. Switch 7 (D/N): When this switch is set
8. Switch 8 (AWB): This switch adjusts white
 ATW (Auto Tracking White Balance): The
 AWC (Auto White Balance Control): It
ON, the shutter speed is fixed to 1/100 sec
(for NTSC) or 1/120 sec (for PAL) to prevent
screen from flickering by the disaccordance
between vertical synchronous frequency
(50Hz for NTSC, 60Hz for PAL) and on-and-
off frequency of a light.
to ON, the camera automatically switches
between color and B&W according to the
brightness of the vicinity.
balancing. When this switch is set to ON,
this camera operates in ATW mode, and in
case of OFF, this camera operates in AWC
mode.
color temperature is automatically adjusted
according to the environmental change.
(Approx. 2000°K to 11,000°K)
stores the color temperature just when the
switch is changed to OFF. Accordingly color
temperatures are adjusted by the stored
value.
Caution
-. The IRIS setting range for the camera is
approximately 80 to 120 IRE. It means
the camera does not provide the IRIS
full open/close feature but the restricted
variation range.
-. Use the camera after setting to the proper
level (80 IRE or above) because the IRIS
hunting may occur when the level is 75
IRE or below.
2007-07-06