Makita DFL082F Betriebsanleitung Seite 4

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Indicator lamps
5 Check button
6 Switch trigger
7 Reversing switch lever
8 Lamp
9 LED indicator
SPECIFICATIONS
Model
Fastening torque
Angle drive head
No load speed (min
Overall length
(Depending on the battery)
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest combi-
nation, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of resi-
dence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
10 Adjust grip
11 Ring
12 Angle head
13 Adjust ring
14 Scale
15 Hole for adjust grip
16 Yellow line
17 Compression spring
18 Socket
DFL061F
Hard joint 1.5 – 6 N·m
Soft joint 1.5 – 6 N·m
–1
) 470
BL1415N / BL1415NA / BL1430 / BL1430B / BL1440 / BL1450 / BL1460A / BL1460B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
DFL082F
2 – 8 N·m
2 – 8 N·m
9.5 mm square or 6.35 mm hex
700
405 – 422 mm
1.5 – 2.1 kg
D.C. 14.4 V
ENE033-1
CORDLESS SCREWDRIVER SAFETY
WARNINGS
1. Hold the power tool by insulated gripping sur-
GEA010-2
faces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the oper-
ator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
6. Always secure workpiece in a vise or similar
hold-down device.
SAVE THESE INSTRUCTIONS.
19 Hole
20 Pin
21 Screw bit
22 Sleeve
23 Limit mark
24 Screwdriver
25 Brush holder cap
DFL122F DFL202F
5 – 12 N·m 8 – 20 N·m
5 – 12 N·m 8 – 20 N·m
410 220
GEB139-1