Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ATTENTION!
To avoid burns by hot steam, do not bend over the
spout (2).
• Once water starts boiling, the kettle will be switched
off automatically and the indicator in the ON/OFF
button (7) will go out. Pour out water and repeat the
water boiling procedure several times.
• Hot water resulting from the first boilings is not
recommended to consume, you may use it for
domestic needs.
USING THE ELECTRIC KETTLE
• Place the base (8) of the kettle on a solid steady
flat and non-slip non-metal surface away from heat
sources as far as possible from the edge of the
surface.
• Ensure that the ON/OFF button (7) is always
accessible and is not blocked by foreign objects.
• Make sure that the kettle is switched off, the ON/OFF
button (7) is set to the position «0».
• To fill the kettle with water, take it off the base (8),
press the lid (3) opening button (4).
• Fill the kettle with water not exceeding the maximal
mark «MAX» on the water level scale (6).
• Close the lid (3) and put the full kettle on the base
(8).
• Insert the power plug into the mains socket.
• To switch the kettle on, set the ON/OFF button (7) to
the position «I», the ON/OFF button (7) indicator will
light up.
• Once water starts boiling, the kettle will be switched
off automatically and the indicator in the ON/OFF
button (7) will go out.
• Before removing the kettle from the base (8), make
sure that the kettle is switched off, the ON/OFF
button (7) is in the position «0».
• After switching the kettle off, wait for 15-20 seconds,
then you can switch it on again for re-boiling.
• If you need to switch the kettle off, set the power
switch (7) to the position «0».
• If you accidentally switched the kettle on, but the
water level appeared to be below the minimal mark,
the automatic thermal switch will be on and the kettle
will switch off.
• Unplug the kettle and let it cool down for 10-15
minutes, then fill the kettle with water and switch it
on, the kettle will operate in normal mode.
CLEANING AND MAINTENANCE
• Before cleaning unplug the kettle, pour out water and
let the kettle cool down.
• Wipe the outer surface of the flask (1) with a slightly
damp cloth and then wipe the flask (1) dry. Use soft
EN
7
Werbung
Inhaltsverzeichnis
