Inhaltsverzeichnis
Werbung
who are helpless, small children or persons insensitive
to heat (e.g. diabetics, persons with skin changes
related to illness or persons with scarred skin in the
area where the pad is to be applied, after taking any
pain-relieving medication or alcohol).
• This appliance may not be used by children unless the
switch has been preset by a parent or a supervisory
person, or the child has been sufficiently instructed in
how to use this electric blanket safely.
• This electric blanket is not intended for use in hospitals.
• Never use the appliance if it is not working properly,
or if it has been damaged. Any intervention other than
cleaning and normal maintenance by the customer must
be carried out by an approved service centre.
• If the appliance is used for other purposes than
intended, or is it not handled in accordance with the
instruction manual, the full responsibility for any
consequences will rest with the user. Any damages to
the product or other things are not covered by the
warranty.
2 | Before first use
This electric blanket is made for preheating beds. Before
you use the appliance for the first time, please do as
follows: carefully unpack the appliance and remove
all the packaging material. Keep the material (plastic
bags and cardboard) out of reach of children. check the
appliance after unpacking for any damage, possible from
transportation. Never switch the electric blanket on when
folded or compressed, wedged between objects and never
make any sharp creases.
3 | safety system
This electric blanket has a SAFETy SySTEm. This
electronic sensor technology prevents the entire surface
of the electric blanket from overheating by automatically
switching off in the event of a fault. If the safety system
switches off the electric blanket automatically as a result
of a fault, the control lights and the indications on the
switch are no longer illuminated even when the electric
blanket is switched on. please note that, after a fault has
occurred, the electric blanket can no longer be used for
safety reasons and must be sent to the service address
indicated.
4 | pLacing tHe BLanket
Spread the electric underblanket flat out on your mattress
so that the cable entrance is located approximately at
shoulder height (see illustration). The electric blanket
can be used on both sides.
1
9
Additional information for using model HL7318V:
The head area of the underblanket is not heated. Push
the plug of the plug-in connection through the hole in
the side (9) of the blanket and connect the switch with
the blanket by pushing the plug in the connection (8)
(see figure). Then pull the side section over the sides of
your mattress like a contour sheet. The underblanket is
designed to fit mattresses of the size 35x80 inch (90x200
cm) and 38x80 inch (100x200 cm). Then secure your
contour sheet as accustomed so that the underblanket is
between your mattress and the contour sheet.
make sure that the underblanket is always spread out flat
and does not get pushed together or wrinkle during use.
check its position when making the bed. The electric
underblanket may only be switched on when it is spread
out flat.
We recommend switching on the electric underblanket
and covering it with the quilt for approx. 30 minutes
before going to bed to prevent the heat from escaping.
First select the highest temperature setting (level 9). This
produces the fastest warming.
5 | using tHe sWitcH
SWITCHINg oN
Slide the on-/ off button (7) on the side of the switch
(1) to position 1 ( I ), to switch the electric blanket on.
The display (2) will light up and show ca. 2 seconds all
functions. After that the display will show the following
basic setting:
Temperature position for the body zone: 0
Temperature position for the feet zone: 0
Automatic shut off: 1h (= 1 hour)
Attention: to ensure that your good night sleep isn't
disturbed the lighted display will turn off after ca. 5
seconds.
SWITCHINg off
Slide the on-/ off button at the side of the switch
to position 0, to switch the electric blanket off. The
illumination and the indications on the display are no
longer on.
TEmpErATUrE SETTINg
press the button (3) to set the temperature for the body
zone. press the button (4) to set the temperature for the
feet zone.
position 0: off
position 1: minimum warmth
17
8
Werbung
Inhaltsverzeichnis
