Siemens SCD 1815-E Betriebsanleitung Seite 48

Main menu Function
Options 2 DPMS
Source scan
Blank color
Frame color
Info signal source
Utilities Language
Calibration
freeze frame
Factory reset
Installation RGB-
Mode
When <+>,
H- and V-
Frequency
H/V-total, H/V-start
Option
H-resolution
V-resolution
H-total
H-Start
V-Start
Install
test pattern
Info Firmware,
Resolution, Timing
LCD-Monitor SCD 1815-E
Adjust function / value / range
ON – OFF
OFF – ON – Standard
red – reen – blue – black
red – reen – blue – black
ON – OFF
English – German
<+> press
ON – OFF
<+> press
<+> press
–
–
Var. RGB-Mode inactive, Mode1, Mode2,
Mode3
100 to 2000 through key (+/-)
100 to 2000 through key (+/-)
100 to 2500 through key (+/-)
0 to 750 through key (+/-)
0 to 500 through key (+/-)
<+> press
<+> press
–
page 48 / 52
Description
Display Power Management System (DPMS) on or off
If DMPS activated, the monitor is turn off (backlight) when a
synch signal is left. The screen is dark.
Standard: ON
Note: To scan new video source is not relevant because the
monitor has one RGB input source only.
Choose the background color of the screen when no input signal
is present.
Choose the frame color of the screen when input signal does not
fill screen (see scaling).
Input source icon on or off
The icon is shown when input signal are changed. The icon
shows the following information's:
signal source (e.g. RGB analog)
-
- Mode number (internal mode number of the timing list)
- Image resolution of the input signal
- H- and V-frequency
OSD language
Adjustment of the internal A/D converter
(following the menu instruction)
freeze the actual shown picture
Reset of values like brightness, contrast,.. to default values
Enter a new timing which is not in the internal timing table. This
function should used, when the shown image resolution is not
the resolution are expect.
When press <+> the sub menu expect 9 timing parameter.
Show the H- and V-Frequency of the present input signal.
Show the used timing parameter of the present input signal
Inactive: used the internal timing table only
Mode1: use the timing parameter and perform a complete auto
adjustment. (usually used)
Mode2: use the timing parameter and perform an auto
adjustment without an automatic image position adjustment.
Mode3: use the timing parameter and perform an auto
adjustment without an automatic frequency adjustment.
Horizontal image resolution (important parameter)
Vertical image resolution (important parameter)
Whole pixel per line (important parameter)
Number of Pixels from H-sync start to image start
Number of lines from V-sync start to image start
Activate the feed timing parameter
Show a test image
Show the firmware version and timing data of the present input
signal
Operating Instruction
DOC-Nr.: B30055DE6.doc