Trouble Shooting - Uzin Utz WOLFF FLAMENCO Original Bedienungsanleitung

System carbide milling wheel disc, #020944:
for removing adhesives, PU- and epoxy-coatings and roughening anhydrite pavements („beating" action) Due
to the aggressive action, the system milling discs should not be used onto chip board.
Milling disc with star wheel segments, #014243
Additional to the new System-milling-disc the milling disc with star wheel segments offers high efficiency.
Producing a high effect of dismounting and an aggressive action, this disc is used for removing coatings and
adhesive residues. The result is a rough surface. Comes with 4 star wheel segments.
Cleaning pad discs 400 mm, 10 mm
For initial cleaning, #013543, For cleaning and mounting of gauze
For maintenance, #013544, For coarse cleaning and removing soil
For polishing, #013545, For polishing, cleaning and wax coating
Super pad discs 400 mm, 20 mm
For initial cleaning, #013546, For cleaning strong soiling
For maintenance, #013547, For coarse cleaning and removing soil
For polishing, #013334, For polishing, cleaning and wax coating

7.0 Trouble shooting

Trouble
Machine does not
start
Switch-on lever (4)
cannot be actuated
Einscheibenschleifmaschine FLAMENCO, #053365
Eventual cause
Power supply
Disconnected
blown fuse
defective cable or plug
Assembly of handle wrong
described in Item 5.0
Safety lever (4) can only be
actuated, if handle not vertical
Elimination
Have machine
repaired by a qualified
electrician,
resp. change parts
Assemble handle like
Lower the handle of
the machine
17