Ryobi RPW140HS Bedienungsanleitung Seite 23

All manuals and user guides at all-guides.com
EN
FR DE ES IT PT NL
■ Use a combination of high and low pressure (high
flow) for heavily soiled areas where constant flushing
is desired.
NOTE: When using either high pressure or a combination
of high and low pressure (high flow), test a small area
first to avoid surface damage.
To rinse:
■ Turn the detergent dial to the OFF position.
■ S p r a y a w a y f r o m t h e r i n s i n g s u r f a c e f o r
approximately 10 seconds to allow any remaining
detergent to be flushed from the hose.
■ Start at the top of the area to be rinsed and work
down, overlapping the strokes.
STORING THE PRESSURE WASHER
See Figure 14.
Store in a dry, covered, frost-free area where the weather
can't damage it. Always empty water from gun, hose and
pump.
Depress the telescopic handle release button. This will
allow the handle to retract. If the handle does not lower
on its own, apply a light pressure to push the handle
down.
NOTE: Do not loosen the locking collar when retracting
or extending the handle.
■ When the pressure washer is needed again, depress
and hold the handle release button while pulling
up on the handle to restore it to normal operating
position.
NOTE:
The use of a pump protector is recommended to prevent
cold weather damage during storage over the winter
months.
MAINTENANCE
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING:
Before inspecting, cleaning, or servicing the
machine, shut off motor, wait for all moving
parts to stop, and disconnect plug from power
source. Failure to follow these instructions can
result in serious personal injury or property
damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
RPW140HS&150HS-23lgs.indd 20 RPW140HS&150HS-23lgs.indd 20
SV DA NO FI HU CS RU RO PL
English(original instructions)
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, petrol,
petroleum based products, penetrating
oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy
plastic which may result in serious personal
injury. Only the parts shown on the parts list
are intended to be repaired or replaced by the
customer. All other parts should be replaced at
an authorized service centre.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service centre in order to
avoid a safety hazard.
NOZZLE MAINTENANCE
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or
dirty nozzle.
■ Unplug the pressure washer.
■ Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
■ Remove the nozzle from the lance.
NOTE: Never point the spray lance at your face.
■ Using a straightened paper clip or nozzle cleaning
tool, free any foreign materials clogging or restricting
the nozzle.
■ Using a garden hose, clear/flush debris out of nozzle.
■ Reconnect the nozzle to the lance.
■ Turn on the water supply.
20
SL HR ET LT LV SK BG
2010/1/22 2010/1/22 2:22 2:22