Faults Table - ETNA AKV578RVS Gebrauchsanweisung

FAULTS

Faults table

When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom
The appliance emits a slight
odour when used for the first
time.
The appliance does nothing;
the lighting is not lit.
Temperature inside
refrigerator too high or too
low.
Appliance makes a noise.
The LED lighting does not
work.
Ice building up.
'dr' shows on the display.
Warning
It is normal for the cooling circuit to make gurgling or expansion noises.
If you are unable to solve the problem then contact the service centre. When you do so, state the
type, model and serial number shown on the type plate or label on the inside of the appliance.
Possible cause
New appliance.
Plug not in socket.
Thermostat setting incorrect.
The door seals are dirty or the
seals are damaged.
Incorrect positioning of food
in the refrigerator (or freezer).
There is an object against the
appliance.
LED lamp faulty.
Freezer compartment door not
closed properly.
The door seals are dirty or the
seals are damaged.
The door has been opened
for too long.
Solution
This is normal and disappears
when the appliance starts
cooling.
Insert the plug in the socket.
Adjust the thermostat
properly.
Clean the door seals. Call
the service centre if the door
seals are damaged.
Place foods in the proper
manner in the refrigerator or
freezer.
Remove the object.
Call an authorized service
technician. Do not attempt
to replace the LED lighting
yourself.
Make sure that the door is
closed properly.
Clean the door seals. Call
the service centre if the door
seals are damaged.
Make sure that the door is
closed properly.
EN 27