Choosing The Right Place; Adjusting The Height Of The Appliance - ETNA OKG254/P04 Bedienungsanleitung

Choosing the right place

Place the appliance in dry and regularly ventilated
room. Allowed ambient temperature depends on the
model (class) of the appliance and is stated on the
rating plate of the appliance.
Never place the appliance near heat emitting
devices (e.g. cooker, radiator, water heater or similar
devices) and do not expose it to direct sunlight.
The appliance should be positioned at least 3 cm
away from the electric or gas cooker and at least 30
cm away from the oil or coal stove. If this is not
possible, use an appropriate insulation.
Class Ambient temparature
SN (sub-normal) from +10°C to +32°C
N (normal) from +16°C to +32°C
Connection to power cupply
Connect the appliance with the cable and plug to the
power supply socket outlet with a ground terminal
(safety socket). Required nominal voltage and
frequency are indicated on the rating plate.
The connection to the mains supply and earthing
have to be made according to current standards and
regulations. The appliance resists temporary voltage
tolerance up to -6 to +6 %.

Adjusting the height of the appliance

The appliance is equipped with four adjustable legs,
so that the height may be adjusted from 82 to 90
cm. The height must be adjusted prior building the
appliance into the opening slot, and it should be set
at such height that the top panel of the appliance
fits exactly below the kitchen worktop (see
Mounting Instructions).