Built In (Ckv720); Built In (Ckb740) - Pelgrim CKB740 Anleitung

installation guide
88
Built in
(CKV720)
Electrical connection
The power supply to the hob is via the oven or the separate operating panel.
Refer to the installation instructions for the oven concerned or the operating
panel.
Power setting table
Type of hob
Cooklight
Electrical connection
Power of element
Front left double
Rear left
Rear right
Front right
Cut opening in worktop
Saw the opening in the worktop. This should be done very accurately (see
table). Also saw out any partitions that may be present. The distance from the
saw line to the rear wall and/or side wall is indicated in the table.
Table
Type of hob
Appliance width x depth
Installation height from top of worktop
Cut out dimensions width x depth
Distance from saw line to rear wall
Distance from saw line to side wall
89
CKV720
x
230 V - 50 Hz
2200 / 1000 W
1200 W
2000 W
1200 W
CKV720
575 x 505 mm
56 mm
560 x 490 mm
50 mm
50 mm
installation guide
Space to be left free around the appliance
cooker hood
min. 600 mm
cabinet
min. 650 mm
min. 450 mm
min. 40 mm
Fitting the hob
Worktop thickness
Height under
the worktop
A certain height under the worktop is necessary if the hob is installed above an
oven. This height under the worktop depends on the following:
- Worktop thickness;
- Installed height of the hob (see table);
- Height of oven at highest point (not including the operating panel).
The required height under the worktop is the height of the oven at the highest
point plus the installed height of the hob less the worktop thickness.
Stick the sealing tape on the underside of the
edge or the glass top.
Don't stick the sealing tape around the corner;
rather cut four pieces to fit effectively in the
corners.
min. 40 mm
side wall
Ceramic hob
Installed height
of the hob
Height of oven
at highest point