Setting Mode - Atag VA55111BT/A00 Benutzerinformation

22
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
Using the detergent
A B
30
20

Setting mode

For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when, af-
ter the activation, the display shows pro-
gramme P1.
If the control panel does not show this con-
dition, press RESET. The display shows
programme P1.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Press one of the programme buttons
again and again until the display shows
the number of the programme you want
to start.
• The programme number flashes in the
display.
• If you want you can set the applicable
options.
4. Close the appliance door, the pro-
gramme starts. The programme dura-
tion starts to decrease with steps of 1
minute.
Starting a programme with delay
start
1. Set the programme.
A
-
+
C
4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the Multitab option.
5. Set and start the correct programme for
the type of load and the degree of soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
2. Press
again and again until the dis-
play shows the delay time you want to
set (from 1 to 24 hours).
• The delay time flashes in the display.
• The Delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is completed,
the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start you have
to set the programme and options again.
1. Press RESET. The display shows pro-
gramme P1.
Cancelling the programme
1. Press RESET. The display shows pro-
gramme P1.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
The display shows 0:00 and the end indica-
tor comes on.