Bixpy PP-333 Bedienungsanleitung Seite 5

MATING YOUR OUTBOARD POWER PACK - BA-OBB-1003/2103
The first few times you connect your device, the connectors are more difficult to mate until they are
"broken-in". DO NOT use force, pliers or other tools to mate your connectors. Be patient and use a
towel for better grip if necessary. Over-tightening the connectors will NOT provide a better water
seal and broken connectors are not covered under warranty.
In general, it is a good idea to fill your connectors with dielectric grease before mating, especially if
you use your equipment in or near salt water.
The connector caps on your Power Pack housing and adapter wires are there to protect your
connectors during storage and transportation. Remove the caps that will be submerged or they will
come off and be lost with water flow. The connector cap on your charging and auxiliary ports must
be installed tightly at all times when near water. NOTE: Never cap and store a wet connector!
MATING YOUR MAIN POWER OUTPUT
1
i.
2
4
ii.
3
Align connector pins (1) with the Power Pack's connector notches (2).
Hint: when new, your connector pins are marked on the outside for
easier identification.
• Push your adapter connector (3) into the Power Pack connector (4)
• Rotate your connector nut 175° until you feel the nut
lock into place.
Hint: watch this instructional video: www.bixpy.com/connect
WARNING:
YOUR BIXPY CONNECTORS ARE ONLY WATERPROOF WHEN
MATED PROPERLY and ONLY SPLASH PROOF WHEN
EXPOSED!!!
E
4