ims PRO SPOT 2600 Bedienungsanleitung Seite 13

Translation of the original instructions
MAINTENANCE / RECOMMENDATIONS
• The operators must have received suitable training in order to use the machine at its maximum potential and
weld correctly.
• Check which welding process is authorised by the manufacturer before attempting any vehicle repair.
• The maintenance and the repair of the . Any work undertaken by a third party on the generator will invalidate the warranty. The
manufacturer will not accept liability in the event of an incident that would occur after this work was undertaken.
• Ensure the machine is unplugged from the mains, and wait for two minutes before carrying out maintenance work. Inside, voltages
and currents are high and dangerous.
• All the welding tools will wear off with use. Ensure that these tools are clean to get the best results.
• Prior to using the gun, check the condition of the different tools (star, single sided electrode, carbon electrode...) and clean or
replace if required.
• Remove regularly the casing and any excess of dust. Take this opportunity to have the electrical connections checked by a qualified
person, with an insulated tool.
• Regularly review the condition of the power cable and welding connection cables. In case of visible signs of damage, organise for
them to be replaced by the manufacturer or a qualified technician.
• Ensure the vents of the device are not blocked to allow adequate air circulation.
INSTALLATION – PRODUCT OPERATION
GENERAL DESCRIPTION
This product has been designed to carry out the following operations in a car body workshop: Dent pulling; welding of nails,
rivets, rings and pins; removal of bumps and dents; sheet stretching. It is not designed for the assembly of metal parts. This
device is delivered with an earth clamp, a gun (with cable), a consumables and accessories box, and an SOOW mains cable.
Accessories
Earth plate
Separate gun lead
Automatic Quick Gun
Manual Quick Gun
Spotter Box
Spotter Box Pro
PRODUCT SPECIFICATIONS
ELECTRIC SPECIFICATIONS
U rated power supply voltage
1N
Frequency
U rated no load voltage
20
Permanent power U
SP
Permanent supply current I
Maximal current of a permanent primary short
circuit I
1cc
Maximal current of a secondary short circuit I
Permanent secondary current I
Type of welding current
THERMAL SPECIFICATIONS
Operating ambient temperature
Storage and transport operating ambient
SPOT 2600 / 2700 / 3900 - 230 V
3900 - 400 V / PRO 230 V/ PRO 400 V
2600


2600 / 2700 3900 - 230 V 3900 - 400 V
1 ~ 230 V
5.4 V
1 kVA
4.7 A
1p
43 A
1800 A
2cc
200 A
2p
2700
3900 - 230 V 3900 - 400 V
 




1 ~ 230 V 2 ~ 400 V
50/60 Hz
De 0.5 à 7.4 V
9 A 5 A
90 A 52 A
De + 5°C à + 40°C
De -25°C à +55°C
EN
PRO 230 V PRO 400 V
 
 
 



PRO 230 V PRO 400 V
1 ~ 230 V 2 ~ 400 V
1.8 kVA
9 A 5 A
90 A 52 A
2800 A
270 A





13