Inspection And Maintenance Plan - HOLZMANN-MASCHINEN ED1080ADIG Betriebsanleitung

 Before each start-up, make sure that the safety devices are in perfect condition and
function properly.
 Check all connections for tightness at least once a week.
 Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
 Use only proper and suitable tools.
 Only use original spare parts recommended by the manufacturer.
20.1

Inspection and maintenance plan

The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the specified limits:
Interval
Before start of work or
after every maintenance or
servicing
Weekly
Annually or after every
1000 operating hours
As needed
HOLZMANN MASCHINEN GmbH
Component
Guideways
Change Gears
Camlock
Clamping Bolts
Turning Spindle
Adapter
Feed gear
Apron
Head Stock
Lead Screw
Feed Shaft
Tailstock
Top Slide
Cross Slide
Lathe Slide
Feed Gear
Apron
Head Stock
Guideways
Head Stock
Lathe Slide
www.holzmann-maschinen.at
What to do?
oiling
lubricate lightly with grease
Check fastening
Visual inspection of the oil levels (via sight
glass)
Grease or fill all grease nipples and
lubricators with machine oil.
Grease or fill all grease nipples and
lubricators with machine oil.
Operate pump central lubrication (the
pump is permanently supplied with oil
from apron)
Change oil
Adjust taper gib
Check V-belt and tighten if necessary
Adjusting feed clutch (factory setting: 120
N)
MAINTENANCE
72
ED1080ADIG