Domo DO314KR Gebrauchsanleitung Seite 21

CHARGING THE UNIT
For the first use, it is necessary to charge the motor for 16 ~ 18 hours to fully charge
the batteries.
To start charging the motor, insert the "L" plug in power supply into the receptacle in
charging stand and then plug the power supply into an electric outlet.
Pull the soft lid sideways to remove it from the charging stand.
Pull the motor out of the main housing then slip it into the charging stand.
The red indicator in the charging stand will light up, indication that the motor is
properly in place for charging.
IMPORTANT NOTES
1. It is recommended that the charging stand always be stored plugged into an outlet,
and always place the motor back in the charging stand whe not in use. Overcharging is
not possible.
2. Avoid charging in a location where additional heating can take place sch as above a
heat vent or kitchen stove.
3. The batteries will be totally charged after 15 hours.
4. The motor may become sligthly warm during charging, this is normal and does not
present a dangerous situation.
BLADE
Your grinder is delivered with three different blades. The bi-chamber food container
is packed with the grating blade in place. The other two blades are stored inside the fit
base together with a spare screw nut.
Grating Blade : for Parmesan, hard cheese, nutmeg, nuts,...
Shredding Blade : for semi-hard cheese, mozarella, cheddar, chcolate,...
Slicing Blade : for slices of Parmesan, chocolate,...
USE
Pull downwards to detach the base from the main housing.
The shredding blade and the slicing blade are stored inside the base.
Twist the cup anti-clockwise until stops, lift it upwards to detach from the base cover.
And, remove the screw nut for blades.
To place the cup back to the base cover, position the interlock bracket ahead of the
bracket slot to seat the cup, twist it clockwise until " click " sounds.
The bi-chamber food container is packed with the grating blade in place.
To interchange the blade, remove the screw nut, select the blade and place it by the
center hole over the base post, put the screw nut back to the base post and turn it until
just tight.
DO314KR