Replacing Of The Illuminant - Pkm 9031 X Bedienungsanleitung

6.3 Replacing of the illuminant

WARNING! The LED-illuminant must be replaced by a competent
person only. Do not carry out the replacement of the illuminant yourself. If
the LED-illuminant is damaged, please contact a qualified professional
(electrical engineer): not covered by the guarantee.
WARNING! Switch off the appliance and disconnect it from the mains
before you replace the illuminant (use the relevant fuse in your household
fuse box).
NOTICE! Do not touch the illuminant with your hands. The sweat on your
fingers will reduce the operating time of your new illuminant. Use a thin
cloth or a thin glove.
I
NSTRUCTIONS FOR THE QUALIFIED PROFESSIONAL
The power consumption of each LED - illuminant must not exceed 2.0 W.
1. The LED - illuminant should have cooled down before you remove it.
2. If you want to replace the LED - illuminant, you must remove the aluminium
grease filter first. Press the lock and pull the aluminium grease filter downwards
(s. fig. below).
3. Push out the used LED - illuminant carefully.
4. Pull the used LED - illuminant carefully out of the LED installation opening
and disconnect the energy supply wire (s. fig. below).
(
ELECTRICAL ENGINEER
~ ~
61
)