Inhaltsverzeichnis
Werbung
2 Open the filter cover.
3 Follow the below procedures in order to drain water.
If the product has an emergency water draining hose, in order to drain the water:
4 Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
Washing Machine / User's Manual
a
Pull the emergency draining hose out from its
seat.
b
Place a large container at the end of the hose.
Drain the water into the container by pulling
out the plug at the end of the hose. When the
container is full, block the inlet of the hose
by replacing the plug. After the container is
emptied, repeat the above procedure to drain the
water in the product completely.
c
When draining of water is finished, close the end
by the plug again and fix the hose in its place.
d
Turn and remove the pump filter.
31 / EN
Werbung
Inhaltsverzeichnis
