Declaration Of Conformity - Bosch GKE 40 BCE Professional Originalbetriebsanleitung

All manuals and user guides at all-guides.com
OBJ_BUCH-716-001.book Page 32 Tuesday, January 13, 2009 3:26 PM
32 | English

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009), 2000/14/EC.
EC Type Certification No. 212 26 95.00 by noti-
fied testing agency No. 0344.
2000/14/EC: Measured sound power level
103 dB(A).
Conformity assessment procedure according to
Annex V.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Leinfelden, 01.08.2008
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
01.08.2008
Assembly
For Your Safety
Warning! Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
Caution! Do not touch the rotating chain.
Do not operate the chain saw near other
people, children or animals. Do not operate
the chain saw after drinking alcohol or un-
der the influence of intoxicating drugs or
medication.
1 609 929 P88 | (13.1.09)
Your machine is double insulated for safety and
requires no earth connection. The operating
voltage is 230 V AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Only use approved
extension cables. Contact your Bosch Service
Centre for details.
When operating the chain saw with an extension
cable, the following conductor cross-sections
are required:
2
- min. 1.5 mm to a max. cable length of 50 m
2
- min. 2.5 mm to a max. cable length of 100 m
Note: If an extension cable is used it must be
earthed and connected through the plug to the
earth cable of your supply network in accord-
ance with prescribed safety regulations.
When using cable drums, these must be com-
pletely unreeled.
Only extension cables of design type H07 RN-F
or IEC (60245 IEC 66) are permitted for use.
If in doubt contact a qualified electrician or the
nearest Bosch Service Centre.
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
et must be of watertight construction and in-
tended for outdoor use.
Cable connections should be kept dry and off
ground.
It is recommended for increased electrical safe-
ty to use a Residual Current Device (RCD) with
a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
If the supply cord is damaged, it must be re-
placed by a Bosch Service Centre.
For products not sold in GB:
WARNING: For your safety, it is required that
the plug attached to the machine is connected
with the extension cord. The coupling of the ex-
tension cord must be protected against splash
water, be made of rubber or coated with rubber.
The extension cord must be used with a cable
strain relief.
Bosch Power Tools