English - i.safe MOBILE IS540.2 Schnellstartanleitung

ENGLISH

FIRST
This Quick Start Manual contains all the important health and safety instructions for using the
device IS540.2 (model M540A01) safely.
Read the "Safety" section of this Quick Start Manual carefully before using the device. If you
do not follow these instructions or do not understand them, this could lead to death, severe
injuries and damage to the device.
Read the Operating Manual before using the device.
The Operating Manual with detailed information and instructions concerning the device
can be found at www.isafe-mobile.com/en/support/downloads
Also read the Safety Instructions before using the device. These can be found
in the device packaging and at www.isafe-mobile.com/en/support/downloads
Follow all instructions given on the device and on the packaging.
Follow local safety regulations.
SAFETY
USE IN EXPLOSION HAZARDOUS AREAS
Only use the device in explosion hazardous areas of zones 2/22 or outside of
explosion hazardous areas.
Before entering an explosion hazardous area with the device,
• make sure that only approved accessories are connected to the device, see section
"Connecting approved accessories",
• make sure that no gap can be seen between the two halves of the device,
• make sure the device is not damaged,
• make sure that all the labels on the device are readable,
• make sure the battery is screwed tight.
If you use the device in an explosion hazardous area,
• do not loosen the screws on the device,
• do not connect any accessories to the device,
• do not open any interface cover,
• do not charge the device,
• do not open the device,
• do not damage the device.
Switch off the device immediately and leave the explosion hazardous area without delay if
• malfunctions occur on the device,
• you have damaged the housing of the device,
• you have exposed the device to excessive loads,
• the labels on the device are no longer readable.
USE OUTSIDE OF EXPLOSION HAZARDOUS AREAS
Do not modify the device structurally.
Do not expose the device to high temperatures.
Do not expose the device to strong UV radiation.
Do not expose the device to processes with high electrical charges.
4