Fcc Regulations; Rf Exposure Information (Sar); Fcc Note - Xiaomi Redmi Note 8 Pro Bedienungsanleitung

FCC Regulations

This mobile phone complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information (SAR)

This device meets the government's requirements for exposure to radio
waves. This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy. The exposure
standard for wireless devices employs a unit of measurement known as
the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this
device has been tested and meets the FCC RF exposure guidelines for use
with an accessory that contains no metal and positions the device a
minimum of 1.5 cm from the body. RF exposure compliance with any
body-worn accessory that contains metal was not tested and certified,
and use of such body-worn accessory should be avoided. Accessory
available in market and must be used to keep use distance 1.5 cm from EUT
to Body for Body-worn operation.

FCC Note

Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
06